3FE Power Steeing Pump Re-install

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 26, 2008
Threads
30
Messages
215
I have gotten my pump out, swapped the resivour over and am ready to put the pump back in.

But I have a problem. To get the pump out I had to first remove the pulley, to remove the long bolt on the drivers side.

Now to re-install the pump I have to reverse what I did, but how do I push the pulley back on?

The stud coming out of the pump is not long enough to suck it on. I cant even push the pulley on by hand far enough when it is out of the 80.

Any advise?
 
Pump pulley. I can't get it on when I have the pump out on the bench, with out a big hit from a hammer (havent done this as, It may mess the pump shaft or the pulley up). When the pump I cannot get enough force to push the pump on the pump shaft.
 
Is this an OEM Toyota pump? I replaced mine some time ago without issue. There is a removable key (woodruff key) in the shaft that fits into the slot of the pulley.

I had to whack the crap out of the backside of the pulley to get it off the original pump. I lubed the new shaft (oh yea, I said it) with moly grease, put the key in the slot and slipped the pulley right on.

If this is non-OEM all bets are off.
 
Back
Top Bottom