3fe - cylinder number 5 missing

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 24, 2015
Threads
16
Messages
106
Location
Tacoma
Trying to track down a misfire, I installed 6 new spark plugs. Number 5 came out almost clean. Pic shows Cyl. 4 and 5, same amount of time in. Maybe 50 miles max.
IMG_20160221_170649.jpg

155 psi compression. Cap and wire have a combined resistance of 5k ohms, well in spec. I used a screw driver to listen to the injector and I can hear it clicking away. Resistance on injector is in spec and there is continuity between the wires coming from the ecu to injector. Also sent these out to witchhunter for service.

What am I missing??
 
Insert the plug into the wire and ground on the block and have someone crank her over to verify you have spark is where I would start
I tried this and meant to ask, can I pull the efi fuse and still get spark? Will disable efi disable spark?

Have you tried adjusting your valves?

Yup, double checked and the reason why I did the compression test. All good.
 
And I'm just curious, why would you think valves?
I went back to make sure they weren't over tight but that and the compression test made me think it's fine.
Just curious to your reasoning.

Improperly adjusted valves can result in either a misfire and/or valve clatter. If one valve adjustment is over tight and the other is loose on a particular cylinder, this could create a change in spark plug appearance for that cylinder. If you decide to adjust your valves again, I would recommend doing so with the engine running.
 
can I pull the efi fuse and still get spark? Will disable efi disable spark?
You won't get any spark if the ECU isn't armed and working. Pulling the 15 amp EFI fuse in the underhood fuse box removes power from the ECU.
I would start with the simple things. New cap, rotor, and wires would be first on my list.
 
Improperly adjusted valves can result in either a misfire and/or valve clatter. If one valve adjustment is over tight and the other is loose on a particular cylinder, this could create a change in spark plug appearance for that cylinder. If you decide to adjust your valves again, I would recommend doing so with the engine running.
Thanks summit. I will have to try the engine running method if it comes back to valves.
 
You won't get any spark if the ECU isn't armed and working. Pulling the 15 amp EFI fuse in the underhood fuse box removes power from the ECU.
I would start with the simple things. New cap, rotor, and wires would be first on my list.
That makes sense then. I was just trying to pull a fuse that would stop fuel. I guess I should look at disabling the pump if I want to check spark.


You never mentioned how the engine appears to run. Does it in fact have a miss? Does it idle smooth?
Yes, it idles rough and the miss is felt through the RPM range. You can really feel the engine start to move once you engage the trans. It does seem to smooth out above 3000 rpm.
 
Last edited:
That makes sense then. I was just trying to pull a fuse that would stop fuel. I guess I should look at disabling the pump if I want to check spark.



Yes, it idles rough and the miss is felt through the RPM range. You can really feel the engine start to move once you engage the trans. It does seem to smooth out above 3000 rpm.
Pull the circuit opening relay in the driver's kick panel. That will prevent the FP from running.
 
Back
Top Bottom