3Fe Cold Start Injector not working

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 15, 2007
Threads
89
Messages
478
Location
30°54'01.53N / 84°04'56.04W
https://forum.ih8mud.com/showthread.php?t=174244&highlight=cold+start+fuel+injector

Think Im may have found the issue with the rough starting engine issue. I pulled the CS injector last night and it was COMPLETELY carbon coated...about 1.5x as thick as it should have been until I scraped the carbon off...including over the injector holes.

Question...should I be able to blow thru the injector if its not connected? I tried spraying carb cleaner into it, but it seems to be completely sealed...I did not connect it and crank the engine yet...looking for advise first.
Dang things are $140 new:doh:...both OEM from CDan and straight price from aftermarket part stores.
 
Has anyone found these to be a problem? Are they cleanable and returnable to service or do they normally go bad?

Talked to C-Dan last night and he mentioned that he had never sold one...seeming to me that its not a high failure rate part...
 
CSI can be serviced.

Using a ultrasonic jewelry cleaner and pumping cleaning solution through it should work.

or

Send it off to get cleaned and flow tested, I use http://www.cruzinperformance.com/fuelinj.html


Also most other Toyotas of that era use a similar CSI that is interchangeable.

I had a CSI stuck open once, I could hear the gas squirting in the intake when the motor shut down, dug around the parts box and found another CSI from another car and it worked perfect.

Good luck...
 
Back
Top Bottom