2F ignition coil...???

[RBHME]

I have a stock 2F / aisin carb and ceramic MAF headers and think my OEM ignition coil is going out..... If I where to replace, what would be your recommendations. looking to keep it OEM but if something is better than OEM than I am very open to it. just replaced all wires from distibutor to spark plugs and from coil to distributor. Any ideas???

Thanks!!!!!

 

[CruisinGA]

Be sure it is going out before you replace...

The year you have dictates what would be an upgrade and what is not worth the trouble.

I upgraded to the electronic, ball bearing, waterproof ignition that is found on all 81-87 2F motors. -Requires the coil/ignitor assembly as well as either modifying your current pushrod cover (hit with hammer) or use a pushrod cover off of an 81-87 motor.

It is vacuum advance, so if your carb is not already ported for vac adv. (depends on year) you will need to have it ported.

 

[Landpimp]

if you just needing the coil, get a OEM they are like $30

if your looking to upgrade(depending on what year now) then I agree with Baily, 81-87 fj40/60.....I love it on my 45

 

[RBHME]

I have a 77 built 10 / 76.

I regards to upgrading, what is the ball bearing benefit?

thinking to go OEM due to the fact I hate hammers.......