2F ez wiring question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 19, 2005
Threads
58
Messages
612
Location
Tacoma, WA
so the ez wiring is done except when I doing the last little bits, I cant seem to find where the "ig switch start" purple wire goes, its a thicky. I already have the coil +, coil -, and its super long so it doest go to the column. also, its hot when the ig is in the on position, it is not hot when in the start position. It seems like i had it also going to coil but not sure. a friend helped with all the motor wiring and he was just tossing me wires saying, hook that there, this here etc... any ideas?
 
obviously it's needed to power the hi current fuel cut solonoid :D

seriously, I wouldn't know on a EZ harness. Are there specific uses designated to different wires?

to excite the alternator maybe? the fact that its NOT hot when starting is interesting...
 
The "start" wire from the ignition switch goes to the starter solenoid coil lug and that is all.

It is hot only in the start position and not in the key on. Are you sure you have that right because what you said in your post is the opposite. There is no wire I know of that is hot in the key on position and not in the start position, unless your ignition switch is bad.
 
hmm. you sure you have the wires connected to the ignition switch properly? Perhaps they are off 180* or something? My diagram says this is the one that goes to the starter solenoid to excite it. You will have three wires going to the starter.

* One from the hot side of the battery to the always hot post
* One "Solenoid Power" wire which has a fusable link and is RED. I think it shares the same post as the one from the battery. This is what powers your fuse block when the key is off.
* This mystery purple wire that is hot when your key is in the Start position.

If this wire is off when the key is on, I am guessing that the wires to the ignition switch are not plugged into it correctly.

good luck Mike!
Dustin
 
The label "ig switch start" would seem to indicate that its the wire that runs from the the ignition switch to the starter or starter solenoid. The fact that its not hot in the "start" position doesn't make sense, tho...
 
dustin said:
hmm. you sure you have the wires connected to the ignition switch properly? Perhaps they are off 180* or something? My diagram says this is the one that goes to the starter solenoid to excite it. You will have three wires going to the starter.

* One from the hot side of the battery to the always hot post
* One "Solenoid Power" wire which has a fusable link and is RED. I think it shares the same post as the one from the battery. This is what powers your fuse block when the key is off.
* This mystery purple wire that is hot when your key is in the Start position.

If this wire is off when the key is on, I am guessing that the wires to the ignition switch are not plugged into it correctly.

good luck Mike!
Dustin

that would make sense, the diagram is here that we were using, pg 10.
http://www.clparts.com/pdfs/ez_wire_wm.pdf

thinking about it for a minute, I think it is wrong. thanks guys

mike
 
Back
Top Bottom