- Thread starter
- #161
OK, Will send pricing after the seal kit is done...
Parting Out 2001 LX470
- Thread starter YardPig
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
OK, Will send pricing after the seal kit is done...
- Thread starter
- #163
No sorry.
Do you have the plastic plates that cover where the third row seats attach to the floor brackets? I need basically all of them. Thanks!
If possible I’m in need of the bezel ASAP.
Happy to remit Payment, please let me know
are you ready to cut out the rear crossmember yet?
Is the passenger side mirror sold yet and how much?
- Thread starter
- #169
Are you looking for blanking plates to cover the entire opening or the trim that surrounds the holes?
Last edited:
- Thread starter
- #170
Switch Bezel - Lexus (74202-60210) - $250.00 shipped less the switch cluster, bare trim. Excellent condition.
- Thread starter
- #171
$200.00 Shipped.
- Thread starter
- #172
I'm on the fence, the frame is mint, and at this point I am going to keep it complete. I may change my mind tomorrow.
The blanking plates that cover the opening
- Thread starter
- #174
I have found one blanking plate, far from your request. I've used the back of this hulk as a storage locker and the weather has turned ugly, I will attempt to unload the items to look further. Thanks!
Hello, looking for the Suction Valve from the AC compressor, if available. It’s the plate on the side of the compressor that the ac lines feed into.
- Thread starter
- #176
I have the compressor in my storage container, but not interested in disassembling it for individual parts, sorry.
Well it’s just that plate with the red plugs you have photographed, only four 8mm bolts to remove. It would certainly be cheaper to ship. You sure you can’t pop that little thing off real quick and sell it to me?
Add: it’s not integral to the compressor—they are sold without that plate by denso. So it’s not worthless without that plate, you can sell both parts separately. The next buyer just uses their plate on the new compressor — I sheared a bolt off in mine and so I need another one.
- Thread starter
- #179
Hi, yes I understand. The problem is sealing up the compressor after removing the plate. I would like to keep the compressor complete.
Gotcha, no hard feelings. Thanks anyway, glws