2" receiver up front

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 4, 2007
Threads
20
Messages
132
Location
Bellingham, Wa
Here's the plan, weld a 2" receiver into the front non-winch ARB bumper, purchase a tray mounted warn winch, be able to winch forward or back. I like this idea mainly because I don't intend to wheel the 80 as hard as the 40, so I don't need a winch hard mounted. Ideas on this? Anyone on this forum welded a 2" receiver onto an ARB bumper or the front end of an 80? Thanks for any info/ideas.

Joel
 
This is on the drawing board for me as well, I'm planning on welding the receiver to the flat part on the top of the bumper sticking out far enough that the winch cradle will clear the frame work of the bull bar vertical rails. Lots of gussets will be involved, I'm kind of into the zen welding thing so I'm not sure how yet.
 
Howdy! Check back a few months on the Copper State Cruiser board. A member built this setup and did a very nice job. It has good clearance and lots of extra gussets/support for side pulls. He posted lots of pics. John
 
Thanks for the link, John, that should help out with the project!
 
Back
Top Bottom