Parting Out 1999 Toyota Land Cruiser

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Greetings, I'd like to buy a torsion bar tension adjusting bolt and the threaded insert it screws into if you have one. I can paypal you or snailmail a check if you'd prefer. I upgraded to OME but couldn't remove the passenger side bolt as it is damaged and wouldn't unscrew all the way out, thus I couldn't index the new passenger side bar properly. Thank you for considering my request.
 
A couple wants if available:
  • Driver's window/lock switch and wood surround for it
  • Driver's seat armrest (the one next to the center console that spins up); the PO of my vehicle removed it and lost mine
 
Don’t mean to be off topic, but for rolling 3 times, the passenger compartment is barely touched. I’ll stop holding my breath every time I watch the gas needle drop in front of my eyes now if I can talk my company into swapping our F150’s for 100’s.

Now to the topic at hand.

Still have the three 3rd row air vents? How about the rear cup holder on the back of the center console?
 
Bezel for driver’s window and lock controls available ?
Engine cover ?

I have the driver window and lock control available. Are you just wanting the switches or the cover? If the cover it is shot

I have the engine cover.
 
Driver's side door panel? I am looking for the topmost trim, where your elbow would rest out the window

I have the top most trim of the driver side door.
 
Do you still have the hood?

Joel, I still have the hood, but I've had a few enquiries about the hood...had we already spoken about it? My apologies if so.
 
I need a rear crossmember.... cut out of the frame....can you do this?
 
I need a rear crossmember.... cut out of the frame....can you do this?

Yes, I can do this. Can you send me a picture of the area you want? I will pm you my cell number.
 
Back
Top Bottom