1996 TLC with trouble code P0305

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 29, 2011
Threads
3
Messages
19
Hello folks,
I was driving on hwy. Suddenly the engine felt pretty rough and at least one of the cylinders misfiring. I did not go where I planned to go and turned back home. Using my OBD II, I found the trouble code. Then I googled around on the web, some folks said it might be the issues with some harnesses. I checked around the EGR and did not see any harness. Could you help me out there? Some pics will be great. Thanks in advance.
 
 
Heres' my 306 saga. Harness pics etc in the blog. The steps I took to located the fault are in there too. Good luck.


cheers,
george.
 
Thanks guys! Those pics are really helpful.

The code I got was P0305. Looks like the problems are with #5 cylinder. Yesterday I replaced all the plugs (NGK V tip, not platinum). Then I drove about 30 miles after canceling the code. The code hasn't come back yet but the engine has some random misfire when idling. Don't feel any roughness when accelerating. The plugs that I replaced are about 12 years old but they are of platinum. They don't look so bad at all: no one is oily or greasy or covered by black tar or something. I was expecting at least one of them is bad because of the code and misfire.

I bought the ignition wires but haven't installed them yet. I guess the wires should be fine: I toughed the wires as the engine idling with some random misfire, I did not feel any shock either from the wires or from the ignition coil.

The air intake hose is broken/break right off as I tried to remove it in order to access the plugs. I ordered one and it's on the way now. To test drive, I used duct tape to put the hose together. Not sure if it has something to do with the random misfire.
Thanks again guys.
 
Show a picture of your old spark plugs in line from #1 to #6.

If there is one that is ultra-clean, it can tell us other things too.
 
Back
Top Bottom