1994 LC - Hydroboost install

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 15, 2012
Threads
35
Messages
172
Location
Santa Cruz, CA
Here's a listing for the hydroboost install I finished recently. Thank you to the folks who helped me through it. My series 80 has a Cummins 4BTA diesel engine -- which combines with the large tires to produce weak braking power.
I bought a hydroboost unit from Sweeting's Power Brake Service.

Below is the before picture, showing the stock vacuum booster and master cylinder, along with the ABS on the right.


 
Last edited:
Kit received from Power Brake Service
The kit requires that you cut the stainless tubing and install the hardware. They have a youtube video that explains it well. Be careful getting the crush sleeve on. I managed to crack the inner nylon tube, and didn't discover it until installed and I saw foaming PS fluid.
 
Last edited:
I bought a new power steering pump, one with two return lines. Two return lines is recommended.
In order to install it.. it was easier to yank the entire assembly. Though it took a half hour to get one of the two bolts off.
The vacuum from the vacuum pump is unused now, but the unit is needed to run the ps pump.
 
Last edited:
The threaded rod connected to the HB was the wrong thread density, so I bought a replacement yoke. This worked fine, and gave a bit more leeway than the stock part.

I cut about an inch and a half off the threaded rod. Make sure to thread a bolt on first, so you can restore the damaged threads
 
Last edited:
A majority of my time was spent trying to connect the HB output to the steering box input. The stock fitting is a flared steel tube.. the HB kit was a regular fitting. The regular fitting relied on a washer. This always leaked a little, even when using copper and smoothing the top of the steering box with a file. What finally worked was using the original steer tube - silver brazed onto a fitting to connect to the HB fittings. The brazing was done at the Hose Shop in Santa Cruz.. in about 15 minutes.

Below is the stock connector (cut off original tubing) with new fitting (bottom) brazed on
 
Last edited:
Final install picture of the HB all hooked up. Braking bleeding was much quicker once I got a reverse bleeding tool.
Braking is very strong now.. closer to what you'd expect in a car.

 
Last edited:
I am looking into doing this when I do my motor sway (6BT) but I have grand plans to try and replace the vaccum pump with an air compressor like the medium duty trucks and busses had. Any idea if there is enough room?
 
Back
Top Bottom