1994 check engine light code 26?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 6, 2006
Threads
11
Messages
33
Location
Kailua Hawaii
I have a 1994 LC with 130000miles I keep getting a CEL.
I cleared the light and drove it on the freeway then went and had the smog check done and it passed. Later on the CEL came on again, I checked the code and it is 26. What is the fix for this code?
I have already replaced the 02 Seniors not long ago.
 
Last edited:
per haynes manual...

injector or injector circuit; fuel pressure regulator
coolant temp sensor or circuit
oxygen sensor or circuit; MAP sensor or circuit
intake air temp sensor or circuit; air intake system
EVAP system; EGR system; ECM or circuit

you may want to pick up a manual or FSM...they detail how to check these components...some involve using a voltmeter, etc....

good luck
 
Turned out to be water in the outside 02 sensor plug. Replaced it with the old 02 sensor and now it runs great.

Wait, you replaced the plug with the old one or replaced the whole sensor?

Replaced my o2 sensors a few weeks back as well after a code 28. Got a new code today I need to pull, but am wondering already if it isnt o2 sensor related.
 
I replaced both of my 02 sensors 1 year ago, and the reason for the replace was because a CEL 21, The new ones from Cdan did the trick.
But I did notice that every time I went through a car wash I would get rough idling and sometimes a CEL.Sometime it would go away on it own and other times I would un connect the battery to clear the code.
This last time I could not get the CEL to clear and got a code 26 and then a 21.
This after just passing a smog check and then going through a car wash.
I decided to check the 02 sensors, the o2 sensor on the outside or left sensor while looking up at them had water in the connector, I shot WD40 in it but it still threw the code so I replaced the whole unit with the old sensor I saved.
That did the trick and have been code free for the whole week.
I called cDan and he did say the sensors are weather proof and advised I could use Dielectric grease to seal out water, so thats what I did.
 
I called cDan and he did say the sensors are weather proof and advised I could use Dielectric grease to seal out water, so thats what I did.

On the new one or the old one??

I'm tellin' ya, they're like spark plugs; they wear out. Just because you're not throwing a code with the old one does *not* mean it's performing as well as the new one (other than the water in the connector issue).

Waterproof the new one and get it in there. (unless you're saying that's what you did...)

Curtis
 
Back
Top Bottom