Parting Out 1988 FJ62 Toyota Landcruiser 2-Tone Virginia Part out

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Do you have the bezel that goes around the radio and dash? Also the bezel that goes around heater controls.
Another one, probably iffy because you said this was rusty, but the OEM bracket that holds the OEM tailpipe rubber, the last one by the end of the tail pipe, attached to the frame under the left rear quarter panel. In this image it's in the bottom right, part number 17430S
Parts Fiche
 
Do you happen to have the grille and headlight bezels or the license plate assembly?
 
My driver's bottom seat is ripped up pretty good, and I am looking for just the fabric from either the driver or passenger side in tan/brown for a 62. Do you have the bottom front seat covers?
 
My driver's bottom seat is ripped up pretty good, and I am looking for just the fabric from either the driver or passenger side in tan/brown for a 62. Do you have the bottom front seat covers?
I do. I would assume it's a later model fabric? message me and we can talk about it.
 
Good morning. I'm looking for the left fender and front end panel. The front bumper would be a great bonus too. See my post below for reference. Do you have these pieces available?

 
Good morning. I'm looking for the left fender and front end panel. The front bumper would be a great bonus too. See my post below for reference. Do you have these pieces available?

Yes I should have a fender and bumper. Valance I don’t think I have anything decent in inventory.
 
Interested in both front turn signal assemblies (the plastic + the wiring harness).
 
Back
Top Bottom