1988 FJ62- Dark Grey with Grey Interior

[charliebucket]

Anything on my above post?
Thanks

 

[Sporttrucker]

PM sent charlie.

Thanks,
Robert

 

[PortFJ62]

4wd vac solenoids??

 

[Dirtgypsy]

4wd vac solenoids??

don't listen to this guy he is confused on how to fix his vacuum at home. besides his rig has yet to see dirt with him behind the wheel

 

[Sporttrucker]

PM sent Port..... No dirt action yet.... such a shame!!! Just don't get too much dirt action like my brother did.

Thanks,
Robert

 

[PScottBx]

Dibbs on the Transfer case if it's good and no worries prior to the roll and tumble.

Thanks!

Scott

 

[cruiser88]

That piece of plastic that pops in the dash I think it is where the mirrow switch is suppost to go on the drivers side next to the dashlight dimmer knob. I have a big empty hole

 

[Dusty 66]

steering box ?

 

[Sporttrucker]

Dibbs on the Transfer case if it's good and no worries prior to the roll and tumble.

Thanks!

Scott

Gray has dibbs on it first but if he doesn't want it your up next.

Thanks,
Robert

 

[Sporttrucker]

That piece of plastic that pops in the dash I think it is where the mirrow switch is suppost to go on the drivers side next to the dashlight dimmer knob. I have a big empty hole

Mine had power mirrors. Would you be interested in the actual switch that goes there? I should be able to get you the harnesses and everything if you decide to eventually go to a powered mirror setup.

Thanks,
Robert

 

[cruiser88]

Mine had power mirrors. Would you be interested in the actual switch that goes there? I should be able to get you the harnesses and everything if you decide to eventually go to a powered mirror setup.

Thanks,
Robert

naa just need the plastic that pops in.

thanks

 

[Sporttrucker]

steering box ?

Steering box is available. How soon do you need it? I'm going to start her up one last time and park her in a final resting place until the tow truck comes to get her when I'm done parting her out. Still runs like a champ even after getting tossed around. They don't make vechiles like they used to!!!

Thanks,
Robert

 

[Sporttrucker]

FINALLY!!! I got some pictures up of the bruised up lady. Still in the condition from the roll over since it is sprinkling outside right now. I didn't have much of a chance to get the interior cleaned up either, since the shop vac is being loned out right now. The engine just had the top end overhauled about 8 months ago. The transmission is the stock one in there with a tranny flush done every year. Has 227,268 miles on it. It hardly ever seen 4WD except for maybe a total of 2-3 days out of the year. The interior seats are in need of attention. I stopped driving this about 6 months ago and my brother took it over and I guess beat it up pretty bad. The seat foam is still intact underneath the vinyl and thin layer of black foam padding. I havea source that could redo all this seats extremely cheap. There are some people that have dibbs on the seats already but if they back down I'll probably end up taking these seats to him and have them redone with the stock style cloth/vinyl on the sides and then sell them as a complete set.

Thanks,
Robert

 

[fj40forlife]

would take axles. if i could get them from kan to cal

 

[Dusty 66]

Steering box is available. How soon do you need it? I'm going to start her up one last time and park her in a final resting place until the tow truck comes to get her when I'm done parting her out. Still runs like a champ even after getting tossed around. They don't make vechiles like they used to!!!

Thanks,
Robert

can you tell Is it leeking ? I can wait nothing soon, its for a future project,

figure pump w bracket too if it's not calmed. PM me price for shipping to 89131

 

[Sporttrucker]

I think I have PM'd everyone here so if you haven't heard from me shoot me another PM or a post.

Thanks again everyone,
Robert

 

[SKINNER]

Is the steering box still available? If so, I am in need of one (mine just started leaking). Thanks!

 

[Turkeypen]

Console, front seat belts, and some screws from Dash.

Robert,

I'm looking for the console (if its not cracked at the attachment points), the front seat belts (if the plastic at the buckles is not cracked/broken and the sleeves around the receiver are not broken), and could use a few of the screws from the dash face.

Ships to 28787.

Thanks,

David Davis

 

[DirtyLittleSecret]

Still waiting for a PM regarding the AT cooler fittings!

 

[RIDDLER]

parts

Hi Robert- I am still waiting on the parts list I sent you back via PM. I know we are back in the work week just wondering if you got my PM back on the specifics.

Thanks

Aaron (riddlespokane@comcast.net)