- Location
- United States
1971 FJ-40.<br> $3600MetalTech cage. <br>
Metaltech Tube fenders w/ inner fenders welded in.<br>
Ford Shock towers<br>
u-bolt front flip <br>
Disk brake conversion front and rear (mini truck front, GM rear)<br>
master cyl. off a mid-late 90's cruiser for 4 wheel disk.<br>
Astro power steering conversion<br>
Custom seat cage w/ nice buckets pulled from a late-model car.<br>
Metaltech stinger<br>
2" lift springs (can't remember who made them)<br>
2" lift shackles (I don't like them, they were on the vehicle when I bought it)<br>
rebuilt front and rear axles (seals, bearings, ect.)<br>
4.11 gears<br>
Aussie lockers, front and rear.<br>
Asin Hubs<br>
Soft top in great shape, w/ soft doors<br>
Great shape Hard doors<br>
33" tires ( not sure on the brand, I was going to replace them but they are ok)<br>
Engine is an "F". Runs good. ( mostly apart right now ) ( was removing to paint ) <br>
3 Speed tranny.<br>
20 gal. extended range tank (this is the Only gas tank, as the factory doesnt fit with the aftermarket seat cage and seats)<br>
Painless wiring harness<br>
I have a complete 3Fe w/ computer, harness, manifolds, injectors, EVERYTHING.<br>
I was going to rebuild the 3FE and put it in the cruiser. I started to remove the 1F and never got any further.<br>
I have some hard top parts.<br>
Interior has been sand blasted and rhino lined.<br>
Jeep rear fender flairs.<br>
Jump seats have been refinished<br>
hard top - ( needs work ) <br>
steel braided brake lines <br>
I have everything needed to get this back together. May only need a bolt here or there...
<br>
If the motor accessories were placed back together and transmission put back in this could be a driver - <br>
Then the only thing left would be to paint it.. I was going to Rhino line the entire frame and body and paint it a dessert tan. <br>
No rust to speak of. Very clean and solid condition. Lots and Lots of parts...
I included a couple of pictures of what I eventually wanted mine to look like... Wanting $3600 obo - will consider trades or partial trades for 4x4 ATV's / Pontoon boat / Truck etc... <br>
You will need a Truck and trailer to pick this up and haul all the parts away. Lots of stuff! Email me at T A C K E R @ G M A I L .COM
<br><center>
