1965 door question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 2, 2004
Threads
34
Messages
214
Location
Spanish Fork, Utah
I removed the stock top because the PO basically destroyed it. Not worth my time considering I had a 1973 top ready to go. I recently found some doors for a 1973. They are not in as good of shape as my 1965 doors. But using the 1965 doors has issues with the top of the door not fitting snuggly with the hardtop.
My question is this, can you use the door window/vent frames from the later doors on the 1965 doors. Please let me know.

If the doors were closer right now, I could figure it out, but they are a few miles away from me. Just wondering if anyone has fooled with this stuff before.

Thanks,
 
That shouldn't be difficult at all. If there are differences, and I'm not sure that there are, you may have to either swap the piece(s) which go from the front of the side top toward the windshield or be a little bit creative with your door seals.

I've got a '65 with a '79 or later top. Whoever did that to me didn't include both pieces of the slide-together top of the door part that goes from top to windshield as part of the top. Still, we've got an excellent seal and the doors close like vaults after quite a bit of experimentation and alignment work. Yours, because you'll be using the same type door with vent wing windows as both vehicles use, should be fairly simple in comparison.

If you can imagine it you can accomplish it.
 
YUP, the 65 doors(if originaly a corragated top 40) will not fit right with a latter(normal top) 40 top. I am almost sure however you can use the upper door frame from the 73 door on the 65 door bottoms(bottoms are the same fit on either)

I had the same thing happen to me, I took the doors off my 65 fj40(corrugated top) and put them on my 66 fj45LPB.....worked but didn't work ;)

65 door uppers are stright up and down, 66+ have a inward curve.
front window frame angle of different
65 door has no weather striping on the top, its on the body

you can sorta see the problem in this pic(65 doors on 66 fj45)
18362358.jpg
 
nuclearlemon said:
73 window frame will fit if the bottoms are not bugcatcher style.

Good point Ige, since some bugcatchers were still out there in 65 [some even into 66] If your doors are the bugcatcher type [glass hinges off of the rubber, at the back of the vent] then your lower door will not have the necessary hole, access, and support for the pivot of a later model vent. Hope this makes sense.
 
65 door has no weather striping on the top, its on the body
THAT explains a lot! When I bought the '65 truck the PO had stuck Home Depot stuff onto the body at where the top of the door closed. It looked bad and didn't work. But figuring that there should be a seal at the top of the door like most other cruisers have put my wife and I through a wringer until we came up with a decent seal with a good door closure.
 
Doh.......I forgot about the bugcatcher issue.

nuclearlemon said:
73 window frame will fit if the bottoms are not bugcatcher style.
 
here is 65 door upper
67590339.jpg



honk said:
65 door has no weather striping on the top, its on the body
THAT explains a lot! When I bought the '65 truck the PO had stuck Home Depot stuff onto the body at where the top of the door closed. It looked bad and didn't work. But figuring that there should be a seal at the top of the door like most other cruisers have put my wife and I through a wringer until we came up with a decent seal with a good door closure.
 
Back
Top Bottom