16" wheel backspace comments

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

3DAMAN!

No brag..just fact
SILVER Star
Joined
Oct 16, 2004
Threads
47
Messages
698
Location
Big Orange Country
Friends,
I haved searched the FAQ and tried the search function but cant seem to find if the 16" wheels will still need the 3-1/2 backspace on a 78 fj40 w/factory discs? I like the look of the old ansen type slotted aluminum wheel but cant find the right rim size/backspacing combo in the 15" size. Seems the closest is 4.00. And I do not want to run spacers!!!! But.
I would listen to feed back on running spacers,
I would also like to find a set of the slotted wheels for sell, ANYBODY GOT ANY LEADS?
Thanks for any info any one can share........................................:beer:
 
All depends on the rim type, some clear fine with 3.5 BS, but others won't and you have to run a 1/4" spacer.
The rockcrawler rims 3.5 BS I have required an 1/4" spacer in the front. On the flip side I do have other rims, similar design, that cleared the front discs fine without a spacer.
 
I had a guy in the shop last Friday for a vehicle inspection running 315s on 16" alloy rims, 79fj40 w/front disc. He still had to run spacers.:barf:

My 16x7 steelies with neutral spacing clear my tre's and drums fine, but don't quite clear the calipers on the FJ60. A few minutes with 4.5" grinder on the caliper took care of that ;p
 
Hey thanks Mark for the feedback. Seems in my search I,ve found the 16" tires are sometimes less expensive than their 15" counterparts with a lot more truck selections. I am more skeptical of spacers than I am of using the grinder. Can some of you that have ground off the factory front calipers chime in with about how much needs to be removed? I would think different wheels would need more or less depending on the manufacture. If you know of any wheels that will work without grinding that might help too. Thanks......DAVE:grinpimp: :grinpimp:
 
On the flip side I do have other rims, similar design, that cleared the front discs fine without a spacer.

Ranger,
Just to clarify, the similar wheels are also 3.5 BS?

Could you provide additional info on these wheels that did not require a spacer:
Design of wheel (Wagon, D hole, etc...)?
Manufacture?
Purchased from?

Thanks,
manny
 
Hey thanks Mark for the feedback. Seems in my search I,ve found the 16" tires are sometimes less expensive than their 15" counterparts with a lot more truck selections. I am more skeptical of spacers than I am of using the grinder. Can some of you that have ground off the factory front calipers chime in with about how much needs to be removed? I would think different wheels would need more or less depending on the manufacture. If you know of any wheels that will work without grinding that might help too. Thanks......DAVE:grinpimp: :grinpimp:

As long as you get a steel wheel, 16" with some kind of backspacing other than neutral [like mine] you should be ok.

I've had quite a few 40s in the shop that only needed about a 1/16th of grinding to clear. My fj60 took a full eighth. Now I know that there's a good deal of metal left before getting near the piston bore, but I still think that 1/8" is as far as you should go.

Hth

Mark A.
 
Back
Top Bottom