02 sensor replacement LX-450

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 4, 2006
Threads
7
Messages
31
Location
Park City
Has anyone changed the 02 sensor on a 450? My son bought the part for his 96 but discovered that the nuts won't take a wrench. 12 is too big and 11 too small. Looks like the PO rounded them. They are different than those on my 97 LC. They are kind of bullet shaped and cover almost the entire stud. I searched the forum and read somewhere that they may be brass or copper. Any suggestions on the best way to remove them? If heating with a torch how hot? Thanks.
 
I just did mine on Wed. They were very easy.....but then again mine was born in Japan and raised in SoCal. I still replaced the nuts with new ones from Cdan just to help out 100K from now when I need to do them again. I 2nd the heat/vice grips. But make sure to add new stainless nuts from Cdan when you reinstall.

Smit
 
Do a search for 02 Sensors...there's a lot of information on this board about replacing 02 sensors. I unfortunately burned 8 hours on my rusty nuts but that should be the extreme.

Dave
 
I did it today on my 94. 3 nuts came easy and the last one made it into an 8 hour project. They are supposed to be 12mm. My theory after haveing done this twice now is that the outer (remember mine is 94) O2 sensor guard traps water and mud etc... and causes that nut to rust more than the other ones. Last time I got lucky and got a 11mm wrench on it and it came off this time I did everything I could and it finally broke. So off came the whole downpipe. For reference. I found the stud to be a 8mm 1.25" pitch which happens to be the same as a Honda's exhaust manifolds so I was able to get a stud at the local auto parts place. It is slightly longer but it works. My rig is extremely clean as far as rust (all the other exhaust bolts came out just fine) yet that one nut on the outer 02 was very rusty. Moisture and heat worked wonders on it. Oh and I no longer have that guard. I'm debating on whether I should put another one on.
 
Back
Top Bottom