ends

Just replaced the tie rods ends. First, the part numbers below match with the dorman parts I found on rock auto. Total at the time of purchase was $64. I did a terrible job measuring the tie rod lengths before removal. Also, had to clean up the threads on the rods quite a bit before...

Gday, replacing my rod bearings on my 1HDFT. Pulled one out to double check markings, only has T7B 4 on it. Any idea if this is standard sized bearings? Seems the sump has never been off. Has 430,000km on it, bearings are pitted.

Good Morning All! 275K 2000 land cruiser. Just purchased recently, 2 inch lift. I have been adjusting the torsion bars in front to get the ride height correct, 21.5 inches hub to fender on passenger and 21.75 on drivers side (finally got it!). Also was able to successfully adjust the panhard...

Note-These are for the 3 piece bumper, not the typical FJ62 single or one piece bumper. These are Toyota parts, not aftermarket. They are brand new in the box. Left and right. I want $100.00. I'll box them up and bring them to the shipper, you pay for shipping.

Bought these then decided to install a ARB on my 80. These are for a 94 but may fit other years. Less than a year old and bought new from Toyota. Asking $125 for both sides.

Im looking for a set of EMF Rod Ends; Thanks