cylinder bore

  1. deeman001

    Looking for 0.060” Overbore Pistons for 1984 2F Engine (2nd Rebuild) - Recommendations?

    Hey everyone, I’m currently rebuilding the 2F engine on my 1984 FJ40, and the machine shop is planning to bore the cylinders to 0.060” over since the cylinders had been bored previously in it's lifetime. I’m looking to source a set of pistons that will fit this spec (0.060” overbore). I’ve...
  2. Eurasiaoverland

    Does anyone have any experience of the 8-valve 15B-T?

    Just to be clear, I am not looking for information on the 15B-F, 15B-FT, 15B-FTE or 14B-T. These engines were all sold to public with plenty of information out there. I am after information on the 15B-T, which was an early (ca. 1995), 8 valve 15B that externally is a 14B-T but has apparently...
Back
Top Bottom