2F Valvecover Swap - Holddown Bolts are too Long..

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 16, 2002
Threads
136
Messages
1,794
Location
Tucson, AZ
What's the trick to shortening up the valvecover hold-down studs from an "F" engine to fit those fancy 2F holddown bushings?

I don't want to hacksaw the studs off over my valvetrain... (just kidding)

Is there a simple solution?

Thanks -

Rocky
 
There is only ONE stud length from 67-80, which covered both F145, F155 and the 2F. If you have an issue with stud length, you might be working with a pre-67 engine, or a post 80 valve cover. In either event, you will have rocker arm clearance issues that are WAY MORE SIGNIFICANT than the stud issues.

Does your valve cover have the 2F embossed on the side perchance?
 
I had the same problem (but no valve clearance probs) - I just made some spacers by drilling out some old flanged nuts to suit.
Rocker cover, rubber thing with washer, flange nut with enlarged hole, fancy dome nut (oem).
Been like that for 3 years now.
 
My cover does have the embossed 2F, and my engine is a '74 (it's the late model 74 that is a cross between the F and 2F).

I think Andrew's suggestion is a good one - I am going to drill the centers out of the stock 2F flanged nuts, and cap them with something groovy looking.

I am planning on saving my F valve cover. I will let people know if the valves come poking out through the aluminum when I start it up (but actually, I would expect to note any interference during the valve cover install...)

Thanks -

Rocky
 
Back
Top Bottom