Recent content by zweisman

  1. Z

    80 Series TCM Comms issue - Won't start

    Found my problem. The input wire to the distributor cap is completely sheared off at the distributor end.
  2. Z

    80 Series TCM Comms issue - Won't start

    Can you link to the instructions about the fuel pump relay? I'm assuming that since my started is working, that it's probably not the AM1 fusable link. Also, I get a voltmeter light with the key on so it's probably not AM2 either. Not smelling any gas, in the engine so I do have a feeling it...
  3. Z

    80 Series TCM Comms issue - Won't start

    I did disconnect the battery earlier for a while to see if that would help and nada. Totally full gas tank. But yea generally I'm thinking it's something with high voltage electrons.
  4. Z

    80 Series TCM Comms issue - Won't start

    In the ON position the CEL is on. Which, AFAIK eliminates the possibility of an EFI relay failure.
  5. Z

    80 Series TCM Comms issue - Won't start

    Thanks for the advice. Any other go-tos for a truck that will crank but not start? Sputtered to death while running?
  6. Z

    '93 - Nonstop flashing CEL when reading codes

    Thank you so much!
  7. Z

    '93 - Nonstop flashing CEL when reading codes

    Hey guys, another issue - I jumped the diagnostic pins earlier today to read codes, got them just fine, (42, 83, 84, 85). Went to clear them by removing the EFI fuse, put it back in, rejumped E1 and TE1, and now the CEL light just flashes nonstop sort of rapidly. Anyone ever seen this before?
  8. Z

    80 Series TCM Comms issue - Won't start

    Hey all, '93 FZJ80 here with ~265k miles. Experienced an issue yesterday where I came to a stop at a red light, engine sort of just sputtered and died. I tried to restart it, and it would crank but just wouldn't turn over. Tried again today, same result. Pulled the codes, got this: 42, 83...
  9. Z

    Need help identifying a hose (1FZ-FE)

    Just purchased the PCV valve kit from wits-end (along with some wipers, panel trim retainers, and a dash light). Thanks everyone! 👍
  10. Z

    Need help identifying a hose (1FZ-FE)

    Just for more information, when the engine is near idle is the only time it makes this noise. When I grab the hose close to the crankcase end, it feels like the hose is mildly collapsed under the intake pressure, which is what leads me to believe the hose has been compromised - but that's based...
  11. Z

    Need help identifying a hose (1FZ-FE)

    https://absolute-wits-end.com/80-series-1fz-pcv-valve-kit/ Is this what I need?
  12. Z

    Need help identifying a hose (1FZ-FE)

    Hey guys, recently I've been having a high pitch sound coming from the engine bay. Turns out its a resonant sound coming from a hose that looks like it goes from the intake manifold to the engine header. You guys might know what it is, it's not abundantly obvious to me, and I haven't seen any...
  13. Z

    For Sale 80 Series Rear Spoiler

    Do you also have the pillars that mount it to the body?
  14. Z

    Massive steering dead zone

    Thanks for the replies guys. Does anyone know of a good walk through on steering teardown/rebuild?
  15. Z

    Massive steering dead zone

    Hey guys, Since I bought my '93 with about 232k miles on it, it's had this huge dead zone in the steering particularly on left turns. When I turn the wheel to the left there's a solid 3-4 inches of rotation abut the steering wheel where it just has zero steering authority, which is particularly...
Back
Top Bottom