@NITC thank you 😇 the aux battery was not grounded rookie move on behalf. Once I had a proper ground flashing stopped and all lights are now solid. Thank you all for your help and support. Just finished wrapping everything up and putting everything back together.
13.2v from the aux battery?? When I charged it last it did show 12.5 at 88%.
I still have warranty from Autozone so I may just go swap it out for a new one and try it again.
I was actually thinking about this I do have the black wire running to the aux battery do I need another wire coming off the aux battery as a ground?
I’m suppose to meet up with a member from here this weekend hopefully to see how his is setup and maybe 🤔 can see what’s going on with mine.
@grinchy no crimp cables and I have not tested each section yet.
@100kiwi yes my plan is to test voltage from the starter battery. At crank when truck is running on the dash it’s showing a little under 14v.
@NITC I did see you post and I did recheck all the wiring orange, yellow, and blue are...
Well I did charge the aux battery to 88% 12.5v and connected everything back up and still flashing A meaning still in standby mode. Any other suggestions or advice will be greatly appreciated I’m all ears.
Waking up this thread.
My question is how long is the A standby mode need, to turn solid because it’s flashing after I turned the 200 series on? My setup is basic, I just have duel batteries setup my main battery and the aux battery led acid batteries.
Thank you for all your help I also...