Recent content by wsudu

Sorry for the bump but man I am stuck.... @PADDO sorry for the mention but is this in your wheel house?

OK like mini boulder/very large rock 3ft tall, tall enough to fit just under the front bumper on high and hit it with my left side tire. I was only going like 5 miles an hour on some BLM land and the sad thing is I was about 40 feet from the gate.

Hi Everyone, 2013 LX570 here. Long story short, I hit a boulder and had to replace the steering rack, knuckle, clock spring and had VGRS codes. Everything is fixed except for code C15A5 (VGRS Actuator). Based on other threads and FSM, I knew I broke the ribbon cable inside the actuator. I...

I hear ya, and I have. I mean, there is some rash on the wheel, but I am not sure it is from that. I have gone over it for like an hour. I was thinking I would at least take the boot off and dig in. I need it to drive as it is daily until I can swap the rack, which I am sure it will need...

Hey everyone, I went wheeling last night in some BLM land near my house. Of course, 20 feet before the gate, I hit something very, very hard. It had to be a rock, but I looked and could not find it. It was at night, and I could not find any damage marks on the truck. The power steering is...

Yes, thank you for this, I'm going to reach out to the local chapter as well and see if there's someone here that has better knowledge of those systems. I have Tech stream, use it often and am familiar with it.

Oh no, I certainly don't think it'll cost me about $1000. Each module is about $450 but, if it's even under $2000, I think it may be worth it just to do it myself and I won't have to deal with the insurance and the buyback and I think it possibly could cost me less in the long term.

Hey everyone, I have a 2013 LX 570, 120K miles. Last night I swerved to avoid some dog looking animal thing going about 40 or so and should've been able to correct it but the VSA or whatever just took over and I was along for the ride. Anyway, she went into the ditch, which is fine, but then...

Real nice 200 Series near Legends today.

I didn't. Not too long after this, I bought an LX570 for the bigger motor and all the other nice things.

Thank you for that, this one does not have any hoops, so I think I'm gonna be good to go.

Yeah I see what you are saying. To me, it doesn't seem significant though. I think I'm really concerned more about the airbag system but I'm assuming that the frame rails etc. are all the same? Any other thoughts out there?

Thanks for the info, but would you be able to elaborate? I looked at your build, and it does seem to be about an inch or so, do you have a spec sheet or something that shows it is higher or do you just happen to know that?

Hi everyone, I have a brand new to me 2013, LX 570 and love it. I'm looking around bumpers and found this one from IronMan: Premium No Loop Bumper Suited For 2016+ Toyota 200 Series Land Cruiser / Lexus LX570 -...

I would too. On my 100 series, they came out quickly, took their time, used rivets, and at $275 was a great deal. He even came back the next day and fixed some wind noise from a molding.