Recent content by Wgood84

Thanks for the advice! looks like I was sold the wrong battery at Advance auto. It's acceptable but not correct. still testing with a bigger closer battery. Anyways for future people don't just buy parts double check all and any before.

@captainva once I test that and if its not getting the correct voltage did you run the wire parallel or replace them? @Toyodajunkie if this test is good and no new wires are needed is that the only parts needed. im trying to get around doing electrical work as much as possible after some of my...

for my benefit lets revive this thread. Problem = when road hunting the vehicle operates perf. when I slow down or stop, the HVAC fan slows and the headlights dim. at idle or stopped the windows are slow with everything else. I need new runs and motors for sure but the HVAC shouldn't bog down...

thanks for the reply. made the hunting trip zero codes. repaired the one I had very carefully. PO had tested from the front and blew out the tiny metal square clip inside. they can be re-bent as to not sometimes throw the code and get stuck in 3rd. anyways on to the next starter voltage...

im also wondering if the wire part number will come with the female that slides into the clip housing and then accepts the ECM. idk thanks

question ?? Im having trans. problems and found a bad spot in the 90980-11390 26 pin connect. at the ECM. the pin S1 is burnt or damaged. the clip is good but the female at the end of the wire is bad. do I need these crimpers to get the job done? its the smaller terminal in the clip. I think...

If it ain't broke dont fix it!

Did you get moved? Need to fix this 1" lean without a coil spacer lol! The Community needs you!

Update ..... cleaning did not work so i ordered the stuff and fixed the trace. Ive never used a soldering iron. It may be a fire hazard, but it's done. Flattened copper with hammer filed it and stuck it through the board.

I'd like to add that I cleaned the corrosion off with MAF cleaner and toothbrush. 500$ is the going rate at this point for a used one that is not for sure good to go. If you get to this point clean it off and if all else fails get yourself a kit off of amazon and go for it! its already damaged...

From everywhere but inside the loop! Well played sir! Lol

The search bar worked. Ive read so many EGR Deletes and this is what i needed. I had a plate installed when the motor was out. Did resistor and no CEL. However...... my 97 has no bottom end power and rumbles in gear and idle. I get a pending P0171. My vac lines are just sucking air! This should...

I'll keep you in mind. Ive been on a road trip reading for hours and did not see PIPs write on this. I did see the steering box crack. Thanks!! thanks to all that came right to the rescue on this. Im new and pumped about it! Might need to get better with the search bar but.... this is a solid...

I was trying to figure out why my sal. Title fzj would have hard shifting and fan hit shroud when flexed from driver side. Looked under and that bar is GONE. Posted about it and now im here! I need a kit just to get it back to safe!

This support is a problem Ive just learned is missing. When flexed from driver side it shifts hard or heavy at the shifter and the fan hits shroud. Passenger side no problems. Should i try and have bar welded in or cut and start over with another assembly if i can source it. Any suggestion's at...