Recent content by WESBC

Activate the ABS and bleed the system. I’ve lived with spongey brakes since the beginning and replaced everything over the years and the only thing that fixed it right away was activating the ABS and pressure bleeding. I wish I started with this first...

Couple weekends ago

You can activate the ABS following directions in the thread below. https://forum.ih8mud.com/threads/is-there-a-way-to-trigger-abs-actuator-to-combat-spongy-breakes.309314/ Did the same thing as you thinking it would get better, pressure bleed and activating the ABS did the trick for me. I...

Dibs, PM sent

I angled mines more toward the side since taking the aerial shot. The ditch lights are BD Squadrons on TEQ mounts

Thanks! They are 3x 100w panels from Amazon to a Renogy MPPT controller. It’s wired to my AUX deep cycle to mostly power my fridge and camp lights.

Thanks! They are S2 Sports - I made a bracket that utilized the turn signal mounting holes and made some filler pieces with some scraps I had laying around. Hello! Sadly, I was not in Moab that weekend.

I lost track but I think I spent less than $1.5k. My biggest requirement was the low profile of my tent so I can fit in a 7’ garage. The one I made is only 3” above the already low profile Bowfin.

No plans for my build kinda just winged it from RipCords build and adjusted sizes as necessary https://www.tacomaworld.com/threads/how-to-diy-wedge-camper.604686/

It’s a homegrown RTT What Did You Do with Your 80 This Weekend? - https://forum.ih8mud.com/threads/what-did-you-do-with-your-80-this-weekend.586191/post-13510685 post #54,362

FJ Cruiser Steelies 17x7.5 (35’s) with 1.5” spacers. Spacers not required, I just wanted the wider stance.

Bowfin