I just moved the rear view mirror out of the way to remove some sticky back Velcro on the windshield and now the mirror glass wiggles uncontrollably while driving. Is there any way to tighten the glass up to stop the wiggle? Can I take the mirror apart?
thanx,
Just an FYI...… I found a Lexus technical service bulletin that describes the zero point calibration with a jumper wire. It worked, and no more lights.
That's what i'm going to do, jumper the 2 terminals. I don't want to jumper the WRONG 2 so am looking for verification. Which 2 are they and which position are they on the DLC3?
Sorry to bother you PADDO,
Unrelated to the AHC issue that I had a year ago or so, I have a question about the VSC TRAC and VSC OFF lights on the dash. Both are on AFTER i had new tires installed AND an alignment done. They only come on after i start to drive. If i turn the ignition off...
2003 LX470.....
I have these lights after new tires were installed and an alignment, not sure if the battery was disconnected for some reason or not. The old tires were larger than OEM but the new tires are back to OEM size so tire size DID change. Lights only come on when I start to drive...
(1) driver side rear, has 1 small side clip broke off and the other 3 intact , electrical part #84810-60040
(2) passenger side front, 1 has all 4 clips intact and 1 has a small side clip broke off and the other 3 intact, electrical part #84810-60040, bezel part #74201-60310
passenger side rear...