Well done! I've fixed a couple of these with the same method, resoldering the flexconnection between the main board and the display board. @sved have really made a great write-up on the fix.
Hi,
Looking for the front seat, grey seat covers (good condition) for a restoration of my 1988 HJ61. I know it's a longshot 😊
I need it shipped to Sweden.
😅😅 You where ahead of your time!
I only had experience with the load valve and the issues it can have with spring lift.
We probably just remove it and see what we get. Good suggestion with a adjustable valve👍
Tha ks for enlighten me and for your drifting story. Makes me want to adjust my brakes...
I'll get a picture soon.
Rear (inner) output from master brake cylinder is to the front, and then to the F input in the proportioning valve, then output to front brakes.
Read about the proportioning valve and it seem like it's toast.
Thanks for the reply. It was setup like this before we changes brakes around.
The little valve is a proportional valve?
R is hooked to rear
F is hooked to front
Rear brakes are great, front not so great.
Stuck proportional valve?
Hi!
First, what is this? It's feeded from the master brake cylinder. Reducer??
Markings: Aisin 8L 65
Issue:
We have good balance between left/right brakes but front brakes are weak compared to rear. No load sensor installed.
Air is checked, no issue.
Front: New Aisin brakes (all done)
Rear...
Sorry for late reply here as well. I didn’t because I wanted to test the stock reservoir and I was pleased with the setup. A bigger reservoir would basically solve the same problem👍