Recent content by Troy Nelson

Good information. I will double check the fuel pump. But it runs fine when under load and on the highway. Also spark plug tube seals were replaced as well as a Pcv valve and grommet. I’m just wondering if the tank was damaged and pinched a breather line if that could possibly affect it?

It does not look like it was tampered with. I did crawl under the vehicle and at some point someone had dented in the fuel tank considerably. Anyone think this could be related?

I am thinking the tps going into the intake and butterfly?

This one starts great but as soon as warms up idle gets a little spotty. I duct taped the intake and it got a lot better but still sketchy. Looking for other ideas. Also anyone have details on calibrating TPS?

I taped it and it made a huge difference but still stutters. Ordered a new one.

Bought one

I will try it. This point I’m at my wits end. I have seafoamed it, nothing, I’m wondering if it has something to do with the throttle position sensor?

If I apply throttle all is well. In fact the po seems to have bypassed this problem by simply adjusting the throttle cable to a higher idle

I know mine is plugged in but I will check all the connections and check it for leaks as well

H hmmmm, I will try that

I have checked the intake too. I have not found any cracks in it. I have just purchased the vehicle and It was having this issue. It also had a leaking valve cover gasket and replaced the valve cover gasket, replaced numerous vacuum lines that had cracks in them and still it is not fixed the...

I have a 1994 80 series that runs great on this call as soon as it warms up it will not idle or only hold about 200 RPM and stutter back-and-forth until it finally dies,I have checked the idle air control and cleaned it and have smoked the vacuum system and have not found any vacuum leaks. I am...

I know this a probably a dumb question. I have a1999 4runner with dual cases. I have a 30 spline output and I am getting a small amount of oil dripping from the rear flange. Was thinking just a seal but replaced it. Possibly rear bearing? If so can I just pull the rear tail cover off and...