Recent content by tjeffries2000

Mate I hope you are correct. Maybe when it is completely loaded the rear will settle and the rear axle will shift back some.

Do you still have some of these? I need one really bad.

Interesting. I measured from the spring pin to the mounting bolts. The front has the longer side to the front but on the rear it is installed with the short side to the front. If these springs are correct EMU lift kits suck. The rear axle should remain centered in the wheel well. Tommy

Is that the same for the rear spring? On the front the long side of the spring is pointed to the front on the rear the short side of the spring in pointing to the front

I'm looking for the rubber door seals that go around the doors and the wing glass frame. A source of someone who could make them would be helpful as well

Hell yes! I am good to go. Thanks mate

Is the light system in series or parallel

I notices my dash lights were dem, so I replace all of the bulbs. After replacing all of the bulbs I noticed no change, so I ordered LED replacements. After installing all of the LED lights. I noticed only two of the lights would light up. After doing some testing It looks like the only two...

All completed. TLC Perf set me up.

I will be keeping all of the smog equipment.

I have an early 1980 FJ 40 pre Aug of 1980. Like the 1979. Wanting to remove the smog pump and remaining unnecessary hoses. Is there a kit out there to replace the pully? I see they have a kit for the latter 1980 and up. Looking for advice. Tommy