Recent content by thecapedcapper

My rear axle bushings are pretty shot, I've had the replacement bushings sitting on my shelf for a while now... Anyone have a set of bushing press tools I could borrow or buy?

So did you ever figure it out? You left us hanging but the crossed out text in your signature doesn't give me high hopes )=

Interested in taking a look at the tent and especially the stove

Lx570 for sub-20k will be a bit tricky but they are apparently out there for first couple years and prices are still coming down. I'd check out the 200 series for sale section here including the "recent prices" thread.

If you still have this would you have any interest in shipping it? I'm in the east coast so not sure if that would be preventatively expensive.

Replaced my gross cargo area carpet with a gym mat cut to size Used the carpet as a template which worked decently but had to trim on the driver's side a but because of the jack mount. This is 3/8" thick. It was also able to fit under the side panels and even the aluminum trim piece...

Bit of an old post but I have a general question about the adaptive cruise: Other than the mph increment changes what is the review of 13-15 vs 16+ Adaptive Cruise? Any major functionality changes? Is it much improved in 16+? I'm thinking of moving to an LX570 for a daily driver and I am quite...

FIgured, I wonder if Rosen would sell just the mounts with lenses for a reduced cost.

Looks good! I take it these still require the Rosen mounts?

Well my truck isn't exactly purdy so I might be interested, bolt on would be easy too! Could you take some more pictures when you get a chance? I think I can see the dent in the second picture but curious to see it in all it's glory.

Do you still have these? How long are the sliders? Curious if they would be long enough for an 80 series.

How long are these? And what would you want for them

Anyone have a set of sliders? Even not for an 80 is fine if they're about the right length (about 63 1/2") I'm fine doing new mounts.

I'm iffy but might be able to make it for a few hours on Saturday. What time is the "meeting" part supposed to be?

I didn't take any uninteresting pictures but got this done... I had in fact put the axle O ring in backwards )=. It was quite the mess... I was however able to take the knuckle / on off with the spindle still attached, wouldn't normally do that but since I had just replaced all of the gaskets I...