Recent content by Teeter

  1. T

    Where does this seal go in the sunroof?

    Amazing, this is perfect.
  2. T

    Where does this seal go in the sunroof?

    Thanks, I’ll check it out. I oooked at a few other part diagrams and didn’t see it. Not really sure where it feel out, seemed like when the shade was half way back? I keep it closed most of the time and this was a panic open to make sure the kayaks hadn’t taken flight, so it was opened pretty...
  3. T

    Where does this seal go in the sunroof?

    In my 2001, I opened the shade to the sunroof (but not the actual glass) and this fell out. It's about the length of the long side of the sunroof. I can't see any channel or place where it looks like it would fit. Any ideas or a diagram someone can point me to?
  4. T

    Spinning nuts the hold on rear spoiler

    I got a replacement rear spoiler/wind deflector for my 2001. It's not OEM (but close) and comes with it's own mounting brackets (the OEM mounting brackets didn't quit line up with the new spoiler). I went to remove the old brackets and sure enough, one of the bolts just spins. The "nut" is a...
  5. T

    Has anyone tried any aftermarket rear wind deflectors that are close to OE?

    Yeah, that's what I have now (the skinny piece of plastic that is apparently really easy to break).
  6. T

    Has anyone tried any aftermarket rear wind deflectors that are close to OE?

    I'm unfortunately looking for another rear wind deflector for my 2001. I lucked out a few years ago when it last broke and found a used original off ebay, but I'm not seeing much anymore in the way of OE. I came across this listing and this listing on ebay that looks pretty close. I don't think...
  7. T

    Jump start ground?

    OK, tried for a 5th time and finally got a good ground on the latch receiver. It started.
  8. T

    Jump start ground?

    This feels like a lame question, but I'm fairly certain I have a dead battery (though my confidence is dwindling because I've never had this much trouble before). I can't seem to find a good spot for the ground. Any recommendations on where? I've tried the latch, parts of the frame near the...
  9. T

    Embarrassing question: How to remove headlight bulb?

    Ok, I finally brought out the big dog 2’ screwdriver and pries it off, it just needed a bit more force than what I could do by hand. Lesson learned was that I think housing female side has 3 slots that look the same size, but are a tad different. The replacement bulb has 3 tabs, two large and...
  10. T

    Embarrassing question: How to remove headlight bulb?

    Ok, I got the passenger side bulb out in 5 seconds by just twisting and pulling so I know the motion. Driver side is just stuck, it’s like the teeth of the bulb are not aligning with the housing when twisted to the remove position.
  11. T

    Embarrassing question: How to remove headlight bulb?

    I can’t seem to get the bulb out of the headlight housing for the primary light. This is on the drivers side behind the battery. It freely rotates to the unlock position (to the left if you are looking at the back of the headlight) but just doesn’t even budge a little to come out. I can sort...
  12. T

    Immobilizer issue?

    Thanks for the tips, though not sure where to go from here.... I checked the 20 amp fuse this morning, it looks fine. I decided to give it one more try after popping in the fuse and sure enough, the LC fired right up. So I am at a total loss as to what is going on. For what its worth, that 20...
  13. T

    Immobilizer issue?

    Th
  14. T

    Immobilizer issue?

    I can’t seem to get my 2001 to start. Turns over fine, plenty of battery, no sign of firing. I noticed when I stick the key in the ignition , the security Immobilizer light above the AC controls does not turn off (I’m fairly certain it used to). I have no original keys, but 2 replicas...
  15. T

    Replacement tweeter recommendations?

    When I opened up the door panel to try and replace mine, it turned out that the PO had replaced them with aftermarket, but the contact was touching the metal of the door (hence my buzzing). Anywho, that’s a long winded way of saying I didn’t need to replace mine, but the ones the PO put in that...
Back
Top Bottom