Recent content by Tdeb44

@Dizzy recommend any specific amperage for that inline fuse? I assume too low and I'll blow it constantly and too high and it won't do much to protect anything. @hobbes it's the stock mechanical pump. The solenoid tested to work but it's seems it's not getting power so I suppose thats my issue...

Hey guys - spent the last few days slowly plugging away at all of the above, looking forward to getting that flasher here to install! Although, I ended up running into another wiring issue. I started it up just to let it run for 20 mins while it's sitting in the garage and after about 10...

1. No, my model doesn't have the amber lights like you sent. Only the signal lights that sit on top of the fender that I sent a picture of. 2. These are quite rusty, I'm having trouble getting bulb out even. Attached a quick photo below.

I swapped out the front apron lamps for some LED lights I found cause original ones were pretty beat up. And I still have the red side markers on the quarter panels. Attached photos of both.

Okay so on your suggestion I'll reinstall the rear lights with original halogen bulbs and I'll start by running a ground wire just to the front signals which are LEDs. There's a ground wire from something else that runs past both front signal lights so I think I'll throw a t-tap in there to see...

Hi all - after the last week of failures thought if ask the group about a wiring issue I'm dealing with. Initially everything was working as you'd expect. But a few weeks back I made the following changes to the lights that has caused some issues: Replaced the headlights with LED bulbs...