Recent content by tabrez

Thanks, will post it there also…yes here in the gcc they had used this 5spd until i think 2016 after which they had introduced a 6spd in the same 1gr fe engine

I had tried 1 bottle of lubegard platinum as recommended by them (had sent a mail to them and they had recommended it to me) they also told to use a second bottle if the problem still persist. Will hav to try that as well. When i had changed my trans fluid i remember my mechanic changed about...

Hi, I have finally been able to pinpoint my source of vibration. Its the 5speed gear in my J200. Got it confirmed from a very experienced garage, after explaining my scenario to him. He also mentioned that its a very small issue and that it can be driven without any problems, but i just dont...

Hello Everyone, I have been observing that my J200 fuel consumption has been increasing over the past few months. Recently i got my Injectors cleaned, MAF Sensor cleaned, New Air Filter installed (stock), Throttle body also cleaned, swapped ignition coil (used), spark plugs also changed; still...

well i have covered all of it. MAF Sensor - Cleaned about 2 Months Air Filter - Replaced with new ones about a month ago Fuel Injectors - Removed and cleaned about 3 months ago PCV Valve - will check on this the problem remained before and after the works done. That what i dont understand...

Not yet fully, the shivering (in steering wheel and body) is still present at highway speeds. The transmission oil was changed about 20k kms before and at the time of changed i had inspected the oil, it was good with no metal parts/shavings. The brakes are good, dont give me a sound or vibrate...

Hi, Small quick question. when at idle and gear in D, the J200 does not creep quickly enough (when AC is off) at low rpm. The J200 does not move if placed at a very slight inclined road (rather tends to move backward) or if its in a pothole, it does not move. Even in slow moving traffic, i need...

Thanks All, Have replace the sensors with new ones.

Hi, I just replaced my catalytic converters (both) and installed new ones. My question is, there are 4 exhaust pipe sensors O2 and Air fuel mixture sensors (i think thats what its called), do i need to replace them with new ones or do i clean them using the ultrasonic machine (which cleans the...

I had installed new driveshaft for front and rear… i double checked it for any play…did not find any issue

Hmm…i was thinking about the same, but everyone told me that it would make some grinding noise…as of now no noise is there in low or high speeds I guess i should have it checked

Hi all, So i have been chasing the vibrations in my lc j200 for quite a while but no luck. There is vibration which is felt in the body, floor, steering (not wobble or shaking left to right) The vibration is prominent betweem 120-130kph but subsides at 140kph ( still felt but very little) and...

Hi, Just wanted to know what are the torque specs for j200 exhaust manifold and exhaust downpipes? Tried searching but could not get. The exhaust pipes are rusted so i think there might be a leak but nothing affecting the mileage or any smell detected. There is a slight vibration in the body...

Rotating the tyres did not make any difference, i had tried with the old tyres. and new tyres are just a week old so.... the vibration actually starts very little from 80Kph but is prominent once i cross 120+ kph, not as per the engine load or gear. I did try putting the gear into neutral...

I had got the alignment done after changing the rims, still the vibration dint go above 120+ kph