Recent content by t140frank

Other than the repaint (which looks good, notice they even replaced the rubber bumpers for the hood and tapped of the data plate on drivers door) The exhaust still has the heat shields, the bottom side is clean, the engine compartment is clean, notice the brand new Toyota radiator cap, the oil...

This will be epic.

Mine came with an old Warn brush guard and a winch that looks like the one in the photo. It bolted into the factory holes, zero modifications. When I removed it I just went back with the chrome bumper bolts. Mines a 60.

Yeah, I used to always write LOT on the welds that failed and needed repair. The welders would always ask if I meant lack of fusion or something. I would simply respond it means LACK OF TALENT. :rofl::rofl: Pissed off my fair share of Pre Madonna welders, it never got old.

Yep, that weld if truly showing your Pipe Liner background. It almost looks like a Lace Cap on a stainless TIG weld. I was always sure you'll guys did that to throw us inspection guys off, makes reading RT film a real pain in the #$@. Side note your billet aluminum air vents on my 60 are...

Seth, I never measured the voltage drop, but I couldn't visually notice a difference. My wiring is in pretty good shape, nice clean grounds and that contact goo stuff on all the terminals I've messed with so far.

Yikes, I just installed those exact bulbs. But I'm using the Koito harness now so I should be ok.

I ran the headlights on the original factory harness for a few months before swapping in the new harness. Lots of night driving ETC, for what its worth the original harness never heated up and I actually didn't notice a difference in the brightness when I used the Koito harness.

Yours if you want it. Just PM me

No problem. It's been rolling the truck for a the last week or two and the dog has been eyeing it pretty hard these last few days. Guess I better toss it into the spare parts box before its a Toyota branded chew toy. :rolleyes:

You'll love the 5 speed did my 87 FJ60 a few months back, along with transfer case rebuild, fly wheel resurface, new clutch and new rear main seal. The rear main was not leaking with 375k on the clock was amazed. If you need a 5 speed shifter knob a I have the I bought when I did my swap, I...

I'm talking about the actually the headlight terminals themselves, they have three prongs. HI Beam, Low Beam, and a common ground. I think the issue is the HI Beam plug terminal that's on the unused factory harness plug is not going to ground and leaving an open circuit and that's why the HI...

Mine is plugged into the passenger side. I think the we could probably run a jumper from the unused factory plug high beam slot to the high beam slot on the Koito harness and close the circuit.

Same thing here, I swapped in the Koito H4 Toyota upgrade. I originally just changed the lights out and ran it off the original wiring harness for a few months, when ran like this the HI beam indicator worked fine. Finally got around to installing the supplied wiring harness, and now the HI...

The 60 series mirrors are still available through Toyota, just bought one a few months ago through Toyota parts deal. Think it was about 40 bucks. Just FYI