Recent content by swiftie

Thanks to Everyone for the help; just shows what a bloody useful forum this is ! "Bye the nou" as we say and thanks

Have changed the fluid several times over the years so tried to do the right thing ! I might try the main dealer (really looking forward to that !) as at least they have the Techstream program which I don't have and get the brakes power bleed out ? How can you get the Techstream program ?

Thank you ! I have a LC200 from 2014 so one of the later models

Dear TeCKiss300, Thank you for your very helpful reply. I'm based in Scotland and corrosion is a big issue as the road salt is endemic. Basically I have had endless brake problems (probably caused by my driving !) and I regularly change pads and rotors and at the moment I have four new...

Quick question ! Does anybody have experience relating to swapping out the brake booster on LC200 please. Specifically concerning either the replacement of the accumulator only from the assembly (cheaper but is it simple/practical/even possible ?) or is it best to replace the entire unit ...

might give them a visit

No problem.. I think I'm right in saying only ~700 Lc200's were registered in the UK so quite a rare vehicle. I know it's probably a bit far for you but Border Toyota on the A68 at St Boswell are quite experienced with 200's. There are quite a few up here and they have been very helpful...

Had the same issue recently with a LC200 which has been on Scottish Border roads all its life, caused by road salt. Mine isn't as bad as yours, looking at your video, but I had exactly the same corrosion on the rear ACH pipes where they passed over the rear axle just by the exhaust. Had to...

Absolutely brilliant; recognised my VIN and your instructions have taken me to the exact part #' I need which was the suspension control pressure hose which goes over the rear axle. Thank you so much. Kind regards Julian

Would anyone know where to access parts sematic/#'s for the AHC on 2014 LC200 AHC please to show suspension pipes and pump/globes. I'm in need of some part numbers to order replacement AHC fittings and pipework. Thank you. Julian Swift

That makes a lot of sense, thanks. Of course in Scotland we don't have rust as its always dry & sunny ! I will investigate but it sounds as if its nothing too complicated. Thank you.

Yes I,d say left side above the axle. So we're saying that its odds on that a metal pipe has rubbed on axle/suspension ?

Greetings from Scotland ! Anybody got any ideas on what might have failed on my AHC as it has pumped the entire AHC fluid from the reservoir (RHS rear) over the rear axle. Obviously I will investigate but initially I wondered if this had happened to anyone else. My concern is I might have a...

I seem to have sorted it. 10amp fuse on RHD European model blown. I did notice when installing the rear LED on the boot/trunk unit that it is possible to short the unit

used to