Recent content by stevebotag

  1. stevebotag

    FJ62 Vibrations on Acceleration

    Apologies for the newbie question but where do the shims get installed?? Does anyone have a link to an installation video? I’m quite competent mechanically so I’ll check the difference in the two flanges when I pull the DS for U Joint replacement… appreciate it
  2. stevebotag

    FJ60 Clutch Issue

    Sorry for the late response! I ended up replacing the master cylinder AND the entire clutch assembly.. turns out things weren’t helped by a leaky rear main seal as well as a new input shaft seal on the gearbox… There was both engine and gear oil all over the clutch. Not Good!!! thing runs like a...
  3. stevebotag

    FJ60 Clutch Issue

  4. stevebotag

    FJ60 Clutch Issue

    Excellent tip… going to try that first thing in the morning once I get the house to myself….ill let you know what transpires…
  5. stevebotag

    FJ60 Clutch Issue

    Master is on order, and yes, easy through the gears when the engine is off. Lower cover is already removed and everything SEEMS to be working as it should… I’ve tried starting the engine while in gear, sometimes there is a clunk noise and then I can shift while running… staring to think its the...
  6. stevebotag

    FJ60 Clutch Issue

    Going to list the issues first and then some of the “fixes“ i’ve tried. Here we go… Clutch pedal had to be pushed to the floor to even consider shifting gears After last 170 mile trip I couldn’t get the truck into any forward gear while engine is/was running, no prob while off.. Won’t even let...
  7. stevebotag

    Gauge Problems (it’s not the sending unit)

    We gauge sourced. I will try the wire bypass test mentioned below prior to install though just to clear the faulty wiring possibility… really appreciate all the suggestions..!!
  8. stevebotag

    Gauge Problems (it’s not the sending unit)

    As the gauge consistently reads incorrectly (doesn’t fluctuate) I’ve sorta ruled out the faulty wire. Having said that, I’ll try your suggestion prior to installing a new gauge. My assumption could be faulty as I’m not to keen on all things electrical…!! Thanks!
  9. stevebotag

    Gauge Problems (it’s not the sending unit)

    Hmmm.. didn’t think of that one. I mounted the new one exactly as the older one but the one I pulled out could have been incorrectly installed. Hard to tell if the old one was factory installed.. I’ll look it up. Thanks!!
  10. stevebotag

    Gauge Problems (it’s not the sending unit)

    So the fuel gauge in my 85 FJ60 would only show 1/8 tank when completely full.. replaced sending unit with new Toyota unit and now the gauge only goes to 1/2 when completely full.. possibly the gauge itself?? I know there’s been plenty of posts regarding sending unit questions, but I can’t quite...
Back
Top Bottom