My kids go to U of Arizona and have my old 1999 LC. I’m up here in Wa state.
CEL came on and auto parts store says its an O2 sensor. Can anyone recommend a local shop that I can send them to for a repair? Thanks!
Selling my wife's 2001 LX470 because she got a new 200 series. Black/Gray. 142,000 mi. Timing belt/water pump done. Recent Mobil 1 oil change. Maintenance records. Runs great. Pacific NW car with no rust. If interested please email me for pics and info.
$12,500 OBO
Steve Snider...
Great to see you guys using oil analysis. I am a Mobil Oil distributor. Under the right program and conditions it is not unusual to see ODIs of 100,000 miles in OTR trucks. I would caution that the word synthetic does not automatically mean better performance over a non synthetic.
Thanks for everyones help with this. As a follow up... I replaced the hoses and heater Ts, went with the metal ones. But after replacing I noticed that the temp gauge was still running very hot. After some diagnosis it turns out that my thermostat was bad. I ordered a new one and replaced...
It was actually the EPA that approved E15 for 2001 and newer vehicles. HOWEVER, the auto manufacturers do not agree. Most have been unwilling to amend their warranties to use blends above 10 percent because tests have shown E15 can damage engines, fuel pumps, emissions systems and other...
That's not true. If you mixed straight Ethanol with non-ethanol gasoline from a pump with an octane of say 87, you would in fact increase the octane. However, that is not what you are getting when you buy blended E10 at the pump. The octane level of the base gasoline used to make E10 is sub...
That's probably a good idea. Thanks
Notice that the T snapped at all 3 hoses at the same time. I didn't break any part of it off. Is that what happens when these things go?
Another dumb question... when I start the truck, shouldn't I expect coolant to be flowing out the hose? Tank is full...
So my t vent just blew. happened as I pulled in to home luckily. I had just bought the replacement T and the hose clamp and have them sitting here waiting for a free weekend to change them out. Any advice? Try to pull the remainder of the old vent out of the hose?
Need some advice.
Looking at buying a 1 owner, 200 series, 2008, 100k miles. Everything is great except that the LC comes from a Northern state. Is this a lot of rust, and would it be a deal killer for you?
Thanks,
Steve