Recent content by Sntryplt

I am looking for a Toyota dealer that serves the same purpose for 4Runners as Bell Lexus does for our GX460s (this is the forum tie-in). A responsive dealer, good prices, and fast shipping. I basically get all my parts from Bell now and would love to have the same setup for our 4Runners. So...

I need some ideas. 2019 - LFD rack, 270* awning, and skid plates. Above 50 mph or so, I have a very soft and intermittent whine on the driver side. Sounds like a brake wear indicator squealing, but I have good pads all around. If the radio were on, I would not hear it. Gas mileage not...

Need a Toyota/Lexus mechanic and alignment shop. TIA Dave

I decided on the OVS Nomadic LT 270* with the wall kit. They are having a sale, and the code VINCEDPRINCE gets you another 15% off. No tax and no shipping fee-I decided against the Deltawing because of the Velcro attachments for the walls. I know Tim Gamiviti did a video on how to modify the...

I think I've narrowed my 270* awning search to either the Ironman Deltawing or the Overland Vehicle Systems Nomadic 270 LT. Both are comparable in price at the moment. Any thoughts about either? Bush Company is great but beyond my price point.

I am looking at the Ironman4x4 DeltaWing 270* awning, since I think the 270 design would work well with our rear door. Anyone have experience with this awning or 270* in general? I have the LFD crossbars on the stock side rails. Additionally, does anyone have experience with IronMan customer...

I have an LFD engine skid plate installed on 2019 GX460. Looking for a filler plate to cover the gap between the bumper and the bottom of the radiator. I've looked online-can't find a vendor or fabricator that has that plate for a 2019. The RCI plate (10-13) does not work-I tried it (hoping...

I don't remember if there's sufficient front/aft "wiggle room". Theo at Rugged Outbound Supply should have better answers; you can contact him at info@ruggedbound.com through their website. He is very knowledgable and helped me out when I was buying and installing the drawers.

Update on the ZPC. Did the reset and CC "recognition" procedure from the FSM and YouTube (with the paper clip method) after installing the new switch module. I got a short straight drive in my neighborhood, but not the 25 mph for 10 sec that's in the FSM. I intended to to out later and find a...

Awaiting on CC module from Bell. I think I know the answer but to confirm: I will install the CC in my driveway but will need to drive about 3 miles or so to a parking lot to do the ZPC with the OBD port shorting method (the straight part is the issue). I will try to do the ZPC in my drive but...

@volklflip88 Thanks. This gives me a lot of good information to go on. BTW, are you an F/A-18 driver? I flew Omega tankers for a few years, before I lost my medical in 2020.

That looks just what I'm looking for. Would you have a chance to measure how far down you ended up on the front and rear? That would be very helpful. Also, did you fit the puddle lights or remove them completely? I haven't looked at what it takes to make the lights work just yet. Thanks!

I have a set of the RCI steps arriving soon. 5* angle with tread plate. Looking for how much anyone trimmed from the plastic rocker trim on the front and rear. Currently, I've found 4" on the front and 2.5" on the rear as measured from the top of the plastic. Any advice is welcome. From the...

If they fit, I have an OEM engine skid (both pieces) from a 2019 that you can have for the shipping cost. Someone smarter than me needs to chime in for the fitment issue. I'm in Cleveland, Tennessee.