Recent content by skip96lc80

All, My '96 LC decided to throw the P0720 code in addition to the P0500 code. I verified that the speed sensor on the TC looks to be in working order, but I'm not quite sure where the output shaft speed sensor is located. Is this the same as the No. 2 Speed Sensor on AT-005 in the FSM...

All, I will be re-building my parking brakes and I have followed the @Poser posts/FAQ but I haven't been able to track down the part numbers for these bolts, they weren't listed in the parts list for the rebuild. I've investigated and looked on different part sites but haven't been able to...

This post has been extremely helpful as I will be re-building my parking brake due to the same issues seen on here but I have a question as to parts. Looking for the part number(s) for these bolts that attach the mounting block. I've investigated and looked on different part sites but haven't...

I personally use CRC Synthetic Caliper Grease. Getting those caliper bolts out can be a chore when they've gone dry. One of the reasons they're not coming out is that there wasn't/isn't enough grease in the boot and slide bushing to begin with when they were last done. Whenever you replace...

I had my tires done at the local Discount Tire, from what I could see they did it right, minus this issue. I checked the backing plate and inner side of the wheel and didn't see any wear or shininess that would indicate rubbing. Just in case today I pulled the wheel and rotor off to see if the...

Did you lube your caliper pins before putting them back in?

That's what it sounds like to me. Didn't even think of this, I was already starting to grumble about having to do the hubs. :) Thank you! I'll pull the wheel and align the discs, and put the wheels back on. --skip

Just rubber.

All, I just purchased new shoes for my cruiser, went from 265/70/16 to 285/75/16's. Now it sounds like I'm getting a metallic grinding noise coming from my rear passenger side, never had this issue before with the smaller tires. There's no rubbing and I have a 2.5 lift from OME installed...

I'm having the same issue, but only about 1/16th of an inch overlap. I did install new rotors but before I changed them I put them on a side by side comparison to make sure it was the exact same and compatible, caliper bolts snug. The only other thing I can think of is to replace with new...

Did you figure out what the issue was?

Looking for a 1996 Front Header Panel. Mine cracked and broke on the passenger side, and is now pointing my passenger headlights towards the ground. Thanks.

Thanks for the assist Dugsgms!!

'96 LC, looking for where the ABS relay is located, photo's are best. The diagrams I have are the crudely drawn one's and don't help much when looking for stuff under the hood. Thanks!

Never mind after some digging I found what I needed. Thanks for the answer LandCruiserPhil!!