Thank you for the reply.
I noticed a small hole at the filler neck which upon further searching it leads to the number 2 at the lower filler neck which is listed as the breather. It seems to be a thinner line together with the filler neck tube as highlighted in the diagram. Should I just shoot...
I have 1994 HZJ80 which seems to have occasional issue of the pump keeps clicking off at the pump like its already full at the fuel station. This vehicle have a single main tank only with 95L capacity.
Recently, it has gotten much worse and it has been clicking off like 10-15 times no matter...
Had similar issue and symptoms as ts and got all excited and went to look for parts number based on vin and lo and behold, its discontinued 😭😭 (90507-29009)
Thanks guys. I was surprised to see mixture of 3 types (shank, short nut and steelies acorn across all wheel with rubbing marks on the wheel 😅 I guess I should have checked them earlier 😭
Hello! I would like to get some insights on what type of seat is on this wheel? It is a 16x8 ET-20 that look like oem toyota alloys but they are not. It just has "Australia" stamped on it. Is this the acorn style? Thanks!
😦😦, I thought grounding out the sender wire is normally what is done to diagnose any problem with the sender wire and gauge. Still does not explain why the gauge will drop with the 76c thermostat. But I will try checking with an infrared heat gun.
Hello! I have a 1995 Land Cruiser HZJ80 with a manual with only 105000km. I have recently flushed the entire cooling system and put in Toyota Red, I have also changed the radiator cap (Denso), upper and lower radiator hoses (oem toyota), Aisin water pump.
I have also replaced the water...