Recent content by Schmiggs

I appreciate the quick response! Makes sense.

I have a ‘66 with a ‘75 windshield frame and I can’t find any information on what these holes are for? They are the ones in the bottom drivers side corner. Anyone know? There’s also a hole on the inside that is roughly the same size as it looks factory but could be a PO modification.

Looking for the core support only.

Do you happen to still have this available?

I’m right down the road from you in Trophy Club. Any chance I can come take a look?

Good point. My understanding is the shaft is easier to find than the bushing? I’ll have it removed by my machine shop to see how the shaft looks.

Certainly, Here’s the pic. I measure 46mm OD x 40mm ID x 33mm long.

Anyone know of a solution to replace a damaged bushing on a one piece 1966 transfer case? I can have one machined at a local shop but wondering if there are readily available parts?

When I bought it it was missing a bolt and the flange at the bolt to the left of it was cracked.

Looking to change from the vacuum shift to a twin stick setup but need the proper housing. Aluminum clutch housing is also cracked.

I'm local and interested if shipping doesn't work out for Airon23.

Any chance this would fit a '66?