Recent content by Saheelo

Did a bit of digging around and found a Cw/P rebuild kit for the rear diff ratio of 4.56 however this is the kit from a LN106 hilux/KUN25 Hilux Diff size is still unsure of 4.88 diffs are impossible here so I guess my best bet would be the 4.56 and 33s. Open to suggestions

So basically my current setup is what you run standard in SA?

Hi all! My 75 series is running on 2 different differential ratios in the front and rear - front is factory 3.56 9 inch ? Axle code K252 Rear Differential housing was changed a year ago from a donor hzj78 series and I’m sure it’s a 9.5 inch 4.11. I am totally aware of the damage I am cause on...

Hi all! My 75 series is running on 2 different differential ratios in the front and rear - front is factory 3.56 9 inch ? Axle code K252 Rear Differential housing was changed a year ago from a donor hzj78 series and I’m sure it’s a 9.5 inch 4.11. I am totally aware of the damage I am cause on...

Correct on that I realized last night that the bearings are different, it seems that both bearings are different ; the external diameter for the H55 is greater by 4-5 mm compared to the H42 however the internal diameter is the same so it’s just the matter of finding the correct bearing and...

An update, I managed to remove the input shafts out of both gearboxes and there’s a difference of about almost an inch. the removal process was a pain 😩😩, I will drive very carefully and try not to destroy the gearbox cause I’m not fit enough to pull it to pieces again 🤣 I’ll update tomorrow...

H55F to 1HZ

Yeah a fair bit of modifications been done one this haha you should see the adapter plate that was in between

H55F bearing retainer length is 4.5 inches H41 bearing retainer length is the 2.75 inches

Those diagrams would imply all the bell housings are the same ? Also those are very detailed thanks

Thanks I just did that here the results and pictures -H41 input shaft length is 7 inches -H55F input shaft length is 7.5 inches

Meaning to say that the Bellhousing between the 1HZ and H42F fit perfectly as that was a running setup, but if I use the same Bellhousing onto the H55F it’s not possible ? I’m gonna be running a Terrain Tamer HD clutch kit im not certain on the size yet but I’m on the way to check rn. ill...

https://forum.ih8mud.com/threads/urgent-advice-needed-in-real-time-1hz-to-h55f.1205457/

Yes it’s a bit too much to grasp at once Anyway I have a new thread up

I have a 1992 PZJ75 and so happens is that the gearbox has been modified by an early owner where he’s stuck a Adapter plate between the gearbox and bell housing, I reckon his gearbox was bugged and he found a replacement but it wasn’t the right one so he had to use that gearbox. However I did...