Recent content by Rupert

  1. R

    Do I need caster correction bushings for a two inches lift?

    Thanks, will do.
  2. R

    Do I need caster correction bushings for a two inches lift?

    I have a '96 fzj80 with no aftermarket bumpers or winch installed. Do I need caster correction bushings with a 2" lift? Also, can I reuse the original stock height shocks? Thanks.
  3. R

    Ironman 4x4 Deals on Suspension, Recovery, Armor and More.

    Bubba I just bought the ironman Toyota 24c and Toyota 25c 2" lift springs. Can I reuse my original stock shocks with them ? Also, do I need caster correction bushings or can I get away with using the original caster bushings?
  4. R

    SOLD FZJ80 Factory Springs / Shocks / Bumpstops

    Sounds good. By the way, is there any rust on the springs or shocks? Has the truck been in a no salt state all of its life? How would we work out payment and shipping? I'm in NY 14215.
  5. R

    SOLD FZJ80 Factory Springs / Shocks / Bumpstops

    Still have these? Was the truck level with these springs? Did you do any towing? Looks like you are selling both the front and rear springs and shocks for $100, correct? What condition are the shocks in? Still firm, no leaks?
  6. R

    SOLD OME 860 Springs

    What is the free length? Please.
  7. R

    SOLD OME 860 Springs

    Please email me the free length and the internal diameters at both ends. I would like to see if I can use it for another application. Thanks.
  8. R

    SOLD Indiana: OME Rear Lifted Coil Springs Land Cruiser 80/100/105 Series

    Please tell me the free length and the internal diameters at both ends. I would like to see if I can use it for another application Thanks.
  9. R

    Parting Out SoCal 1997 FJ80 Land Cruiser

    What coil springs are you running and what is their condition?
  10. R

    OME Suspension and caster correction

    Thanks green.
  11. R

    OME stock height question and pics please !!

    Thanks guys, well said.
  12. R

    OME Suspension and caster correction

    Thanks enox, will check out cruiser outfitters later. By the way, do you figure I can stick with the original caster bushings if I use the 851 & 860 or 861 & 862 combo? Or will I need two or three degrees caster correction bushings with these new springs?
  13. R

    OME stock height question and pics please !!

    Thanks Flint! By the way, do you figure I can stick with the original caster bushings with either the 851 & 860 or 861 & 862 combo? Or will I need a 2 or 3 degrees caster correction bushings with these new springs?
  14. R

    OME stock height question and pics please !!

    Thanks flint! I'm also looking at the medium alternative 851 18.7" front & 860 18.9" rear. These should work fine with the stock shocks, right? Do you think I will end up with a 'stink bug look?'
  15. R

    OME Suspension and caster correction

    Guys, I'm planning to run 851 front & 860 rear, anyone know if this setup will keep the truck level? It's completely stock, no special bumper, etc.
Back
Top Bottom