Recent content by RstBckt

  1. RstBckt

    SAS SAS #10 Official Page 8/03/26-8/07/26

    Sweet. I was on your trail ride today in the green 80. Let me know when you're available. You can text me at (704) 701-0881
  2. RstBckt

    SAS SAS #10 Official Page 8/03/26-8/07/26

    Anyone have an allen key set? Or more specifically an allen key for Rosen sunvisors? Mine grew legs
  3. RstBckt

    SAS SAS #10 Official Page 8/03/26-8/07/26

    I've got 11/32 transmission hose and clamps if that will patch it. I'm in KOa cabin CC2 near entrance. Bert
  4. RstBckt

    What Did You Do with Your 80 This Weekend?

    Exactamundo. TW requires you to swap flanges on T-case and driveshaft. This is direct fit. My FZJ80 is a 66mm square pattern for what its worth
  5. RstBckt

    What Did You Do with Your 80 This Weekend?

    Behold!
  6. RstBckt

    What Did You Do with Your 80 This Weekend?

    Started the weekend early an put a new rear driveshaft in. Standard length and travel but 2.5" D, .120 wall and 1350 joints in my 1995 FZJ80. It is very well balanced btw. Highly recommend these guys Home | Custom Driveshafts from Full Torque Driveshafts Inc. -...
  7. RstBckt

    Another Fender Trim

    Thanks! I'm going to flex it back out sometime soon and I'll post a pic I've seen it done by other members. More stitch welding involved than folding over but if you have rust holes you don't have much of a choice. Maybe get some galvanized sheet for yours. I'm going to pull out the...
  8. RstBckt

    Another Fender Trim

    Final product.
  9. RstBckt

    Another Fender Trim

    Driver side I had to drill a new hole with a step bit for the sunroof drain to move it up. I folded all the original outer fender over and bent it up in and tacked it either along the bottom or to the inside of the inner fender, if you follow. At the rear corner I made a few pie slices and...
  10. RstBckt

    Another Fender Trim

    At the rear of the fender there is empty space so I removed a lot. This moved the corners up a few inches.
  11. RstBckt

    Another Fender Trim

    I used a 3lb ball peen, both sides, get the inner fender stretched. Then used the harbor freight body hammer set to final work the inner to the outer. Used the chisel headed hammer and a dolly with some pvc 20mil sprinkler repair tape on it for the gentler movements. Made a .5" fold of the...
  12. RstBckt

    Another Fender Trim

    Here is the first lip cut: Then what I drew for where I wanted to end up:
  13. RstBckt

    Another Fender Trim

    Looking at various trims I tried my own method. I finished my lift on my 95 FZJ80 and went for a trial run in Tahuya SF, WA. After shredding my new to me rear tires in a black diamond trail that was basically bomb holes in a dirt trail I needed to do some fender trimming. The rear damaged the...
Back
Top Bottom