Recent content by rsharp

  1. R

    Overheated in Death Valley

    What helped more then overhauling the fan clutch was flushing then entire cooling system about 10x and then replacing the half clogged radiator with a new Toyota 3-row brass unit. Several trips to Anza-Borrego, the Orocopias and JTree have shown coolant temps running from 183-188 normally. Last...
  2. R

    Overheated in Death Valley

    I "changed the fluid" in my eaton fan clutch last fall after discovering that it didn't engage at all when driving up silver canyon in the white mountains. After splitting the two halves, use a blow dryer on the coiled flat spring on the front half. This will cause the valve to open. Put a small...
  3. R

    New Member - SoCal

    I'm in Hawthorne, just an hour or so down the 405!
  4. R

    Short block engine rebuild, need some advice

    I believe it, as I also have a cracked short block on my new-to-me last summer 3x locked LX450. Mine is at the bottom if the freeze plug just aft of the oil filter. I noticed the freeze plug was moving out of its hole and weeping during a trip to the White Mountains in CA. I pulled the freeze...
  5. R

    93-97 Coolant Temperature Gauge Modification

    I did this mod a couple of weeks ago with 100/180 ohm resistors. The gauge reads 150 at the bottom line, 201 when the needle is level and 217 when it first touches the bottom of the red. This is perfect as far as I am concerned. I spent the last three days wheeling around Anza-Borrego and very...
Back
Top Bottom