Recent content by Rogerr

checked and ok Update 02/05/2026 Stand allone the high beam indicator works when I put direct power on it If H4 is working I can now flash and have continue high beam, but only with H4 on The strange thing is when I connect the high beam indicator wire on RY wire, it does not work and yes power...

thx, it is a new one the PO told me

ah ok thx I adjusted this and put the old resistor in place I wired the BW ground wire from the panel directly to the ground (location fuses) I also found the connector with RY and RB wire The PO did take this connector for his radio :( I estimate this is a missing part why flash is not...

Indeed, its the same:)

Hi, is this what you need? so: there are 3 red colored wires in the handle RW=high beam in combination with Main light connected to RG R= flash connected to Red/Blue? and leaving as RY for flash My thought is that the red wire needs to go to the Red/Blue wire (only left over) see handle...

Yes indeed with the RW wire I have high beam, pushing the handle to the dasboard And no flash light, pushing the handle to the steering wheel on both no blue indicator light So how is the connection made with the R wire and the HF/dimmer switch then (as this R wire was cut of in the harnas)?

its a 24V 1977 BJ40

Found the red wire in the harnass cut off Now how to make the connection between the red wire and the HF part, what is the color of this wire in the dimmer switch?

Next question: I found the red wire, it was cut of in the harnass:( How now to find the connection between red wire and the HF connection? What is the wire color from the HF connection?

did check and ok

RY wire has power with high beam, so grounding is then the next check. When I put power on RY high beam is on, but not the indicator

PO did do some working arounds including tinkering and fiddeling electric level is not how I would like to see/have it. As the dashboard is new All the other lights are working Some grounding issue? How did you solve this problem?

not sure dashboard is new

Hi gang, Wire RY on the wire connection to the dashboard has power, see picture High beam lights working in both handle positions Dashboard high beam Light itself is not stuck If I put power on that wire the high beam light is working, not the high beam light indicator Dashboard lights are...

nice job :) yeah, flasher high beam is not working, and main head lights go out when flashing high beam Contacts handle are fine So power on fixed High beam is there, but no power for flash high beam