That’s it, is off at the crank. The dot should be on the mark and the two close marks should enclose the bolt hole when installing. He had the crank at TDC with the cams advanced to the timing marks.
Honestly it looks like gnob is right and the Aisin kit that was used called out the “I” as the timing mark and not the “T” as shown in my other pictures. Did your kit call out the T instead?
Assuming the timing is off would there be an obvious issue with how it runs if it’s only off by that...
So the marks show above when he replaced it are correct?
Seems like the consensus is to pull off the timing covers and see where they line up at. The bottom end is at TDC when the mark is at 0 degrees, right?
Hello,
I had the timing belt done on my 4Runner and the mechanic sent me a message that it has a CEL on and is throwing the P0011 Code. He provided videos of the timing belt and everything appears to be timed up well and that the belt is tight. See below.
Here is the left Cam
Right Cam...
Hello,
There is a gx470 for sale near me that I can get for 6k. Just had the rear bags, timing belt, and radiator replaced. Has an extra trans cooler for towing and 265k miles.
Overall sounds really good until he told me there is some RPM fluctuations around 65-70mph. This would be my first...