Recent content by PVCsnorkel

If it is alright with you guys, I'd like to post pictures of each day's activities on the Facebook group. If you guys are fine with that make sure to post them on here so @YotaFun or I can post them.

Yes we are still very much active! Most of us are on the east side of the state, but you are more than welcome to join us. The requirements and instructions for joining the club in the post you quoted are still accurate. Personally I am hoping to make a trip next year out to Alleghany...

I just found out there is a new offroad park opening up in East Stroudsburg. They're having their soft opening this weekend so there isn't to much detail or an official address yet. It's only 90 acres, so a little small. But it sounds like they're focused on making technical obstacles over...

This is the best thread I didn't know I needed. I need to fix my 60 so I can haul my 17' aluminum canoe around (and do some paddling).

I adjusted that when I set the pedal height. I guess I'll have to check the rear brakes for adjustment. If its not the rear brakes, my next guess would be the booster is bad?

I finally got a few minutes to check the booster pushrod adjustment...and it is right where it should be. I let all the vacuum out of the booster by pushing on the pedal several times and made sure the booster rod was pushed back into the master all the way. I thought this was going to be the...

It probably relates to their increased use of AI, I know they they started using AI to screen Marketplace ads. Speaking of Facebook AI @YotaFun can you disable the AI in the group so it doesn't continually post annoying questions.

I'll help with the page as well. @YotaFun are you Joe DeStefano? I just a post about getting the page on track.

Good thing I have a 3 foot long 3/4" drive torque wrench hahaha

I was thinking I could do an operation like this to fix the issue. The driver's side front eyelet pin is out of position and needs to be reset too since I'll be in there, so I at least have to drop that side in the front. I'm hoping the center pin isn't screwed up so I can just tighten it with...

About 4 and a half years ago I replaced all the suspension in my 60 with an OME Heavy lift, Anti-inversion shackles and a U-bolt flip kit. I was under it last weekend power washing it and I discovered that the rear spring packs have come lose and are out of place. From what I saw, the center...

I started working down the list of brake adjustments in the FSM. No. 1 - Pedal Height My pedal was way to low, so I adjusted that back to where it should be. Brakes feel much better and its not going to the floor anymore to stop. However it doesn't have enough power to stop completely above...

Which part is the bell crank?

I ordered one from the link Jim sent me, but thank you for the offer! I was reading the FSM today, and I think my rear brakes might actually be a little under adjusted. The handle comes up almost all the way before it holds.

Sweet!!! Thanks. No worries, I totally get that. I've been going to work to relax lately hahaha.