Recent content by Pat4wd

Only got a few pics. Just got busy talking to folks. 😕

T

Uh....You did, directly above ^^^ Yea not wanting folks to think it may be the last one shouldn't start with "this may be the last one" Hahaha 🤣

Hopefully this is not the last one. Always look forward to this swap meet and show.

Always a good time!

Ah good deal, haven't went before need to check it out.

Looking good!!

Nice! Yea have been going back and forth for sure on the dimples. But i have the dies :) hahaha

Here is how far mine hang out with 35s

How many leaves you going to run? Overload? The chevy leaves are pretty thick and do pretty good with wrap. But if you aren't running but 2 might be a problem. I am running 3 and overload, rides good and I doubt any wrap issues.

Started my Bumper sides. VERY time consuming. I am thinking dimple die hopes on the side? Going back and forth at least. Like the clean sides but like the dimple dies too and it would match my front bumper with so in there, and of course make it a little lighter and more rigid. Also the...

Those tubes are WAY BETTER than a factory toyota housing! Looking good!

Nice looking mounts! Not sure I would go inverted like that, and I dont think you would ever be able to achieve that uptravel either. The springs will have a much shorter life if you are able to travel that deep.

I hear you on keeping it low. Those are just 4" shackles on mine. I did not french this time though. I ran 3 leaves and then over loads as well and I am glad I did for this heavy 2nd gen. Ride fantastic too. So far it is looking like a great combo for the 2nd gen. My other goal was no...