Recent content by Nbleak21

  1. Nbleak21

    '91 - Cranks, but no Start unless I pull EFI fuse. What Next?

    Yep, Fresh OEM cap and rotor are installed ;)
  2. Nbleak21

    3F-E clean engine bay... what can be eliminated?

    Not oil free, as mine will likely never be, but there's a bunch of (what I consider) auxiliary s***e that personally I could do without... So In looking over all the mess that is abound in the 3F-E what all can I eliminate? -DeSmog: will likely be the first on the list. Looks pretty straight...
  3. Nbleak21

    '91 - Cranks, but no Start unless I pull EFI fuse. What Next?

    After a round-about with the post office, I was able to pick up my $76 Dizzy today... Quality of construction vs OEM appeared on-par... However, The cap and rotor were definitly not of the same caliber and I was a bit concerned about the overall "finish". I ended up pulling the coils from the...
  4. Nbleak21

    '91 - Cranks, but no Start unless I pull EFI fuse. What Next?

    I measured the coils at the Dizzy plug. After that I removed the cap and inspected the wires. Could find no breaks or apparent issues through visual inspection so I suspect you're right internal coil issues. I went ahead and ordered a cheap replacement unit ($77) on fleabay... I figure if it...
  5. Nbleak21

    '91 - Cranks, but no Start unless I pull EFI fuse. What Next?

    Alright, the FJ replicated the No-Start condition later today so I checked the Dizzy Coils: NE coil: 235ohm, G coil: 2.3Mohms. ECU reset did not remedy problem, perhaps it was just coincidental... So it looks like my Dizzy is out or on its way out (I assume that since it runs sometimes that...
  6. Nbleak21

    '91 - Cranks, but no Start unless I pull EFI fuse. What Next?

    Jon, Thanks for the tips. I'm in the process of going through these right now... I've not yet checked the resistance but did pull a MIL code of 12 which indicates potential issues with the Dizzy Coil. Of note, I also have MIL codes 21 and 28. Looks like the previous owner had some exhaust work...
  7. Nbleak21

    '91 - Cranks, but no Start unless I pull EFI fuse. What Next?

    No Fire at all. The ignitor has a 5(?)pin connector, in testing those pins one has 5v and another has 12v. I don't recall which positions they were in but according to some research I did, these voltages were what was to be expected. Note: I did not test the ignitor itself, only the the...
  8. Nbleak21

    '91 - Cranks, but no Start unless I pull EFI fuse. What Next?

    Recently purchased my first LC, love the vehicle, performed most all of the base-lining recommendations (Oil, Filter, Plugs, Plug Wires, Dist Cap & Rotor, Battery...) as PM and it has run flawlessly until it left me stranded at work Monday night. On Tuesday evening I did some troubleshooting and...
  9. Nbleak21

    AC System + Headlamp/Brake Lights

    Another vote for inspecting grounds.
Back
Top Bottom